Qingdao, Shandong
Cyclone Sand Desander Delivery
The cyclone sand remover ordered by Shandong Manager Liu was photographed. The caliber is
, the pressure is
, and the sand removal diameter is
, the actual picture of the effluent turbidity is
degrees.
From the picture, the eccentric position of the cylinder above is the water inlet pipe. This is because the cyclone desander uses the principle of centrifugal separation to remove sand. When the water passes through the water inlet pipe of the cyclone desander, a diagonally downward surrounding fluid is formed along the tangential direction around the cylinder. The water flow rotates and moves downward. When the water reaches a certain position of the cone, it turns to flow along the axis of the cylinder. The center rotates upward and is discharged through the outlet pipe. Under the action of the centrifugal force of fluid inertia and its own gravity, the impurities fall into the conical slag hopper at the bottom of the equipment along the wall of the cone. There are components at the bottom of the cone to prevent debris from rising upward. When accumulated, When the debris in the slag hopper reaches a certain level, as long as the manual butterfly valve is opened, the debris can flow out of the cyclone desander under the action of water flow to achieve the effect of sand removal.
If the water flow enters the equipment tangentially from the sand removal inlet under a certain pressure, it will produce strong rotational motion. Due to the different densities of sand and water, under the combined action of centrifugal force, centripetal force, buoyancy and fluid drag force, The water with low density is made to rise and be discharged from the water outlet, and the sand with high density is discharged from the sewage outlet at the bottom of the equipment. This is the principle of the cyclone desander based on centrifugal sedimentation and density difference.
Shandong Qingdao cyclone sand removal and delivery